4ms PEG do-it-yourself kit


The Pingable Envelope Generator as a DIY kit.

All electronic components as well as the blank PCB and a faceplate are included. Although the english manual explains the buildup process quite well but you still should bring some knowledge in electronics and soldering  skills.


Contained with the kit are:

  • a bill of parts
  • a PEG faceplate
  • an unpopulated PCB
  • twenty-two 3,5mm jacks with nuts
  • a number of headers, buttons, jumpers, transistors, resistors, LEDs, capacitors, ICs and IC sockets etc.
  • flat ribbon cable 16-pin, 20cm long

Technical info about the PEG can be found on the product page of the ready made module.

As with all DIY kits: We are not responsible if your kit does not work or if anything gets damaged. We can´t give advice how to solder or how to build the kit. If you are not sure if you can finish the project, then don´t start it.

0,2 kg
Article Number
availability ? immediately available
€ 19% VAT excl. €192.44 € 19% VAT incl. €229.00
Excl. 19% VAT, Excl. shippingLieferzeit 1