Analogue Systems RS-95e

Overview

The RS95 by Analogue solutions is a premium, british sounding VCO with waveshaping possiblities. It is based on the RS90 but has more features, predominantly a very special sine wave. The RS95e presented here is technically identical but instead a normal frequency control it features a gorgeous, lockable (!) potentiometer with ten turns. That allows precise fine tune control and adds the look of an EMS synthesizer to the VCO.

Views

Details

The RS95e has three audio outputs: pulse, triangle and sine.
The upper shape control affects the pulse width. The lower shape control not only morphs from a falling sawtooth over triangle to a rising saw (or: ramp) but simultaneously alters the sine wave and produces a kind of smoothed, softer sawtooth. Additionally the saw/sine output is a CV-INPUT for the symmetry of the sine. Very extraordinary feature that all are voltage controllable. The wave shaping is derived from the EMS oscillators but here the PWM and the triangle shape are separated.

The oscillator sync is „soft“ and not only reacts to square waves but works with all waveforms. The frequency control has three switchable modes: STD (standard) with a range of two octaves. -2 is two octaves lower than STD. WIDE mode gives a range from 0.3 Hz - 17kHz and thus allows use of the RS-95 as VC-LFO with waveshaping options! The „vary“ control not only attenuates but also can amplify the pitch CV. It controls linearly from 0V over 1V/oct to 0.4 V/oct

miscellaneous

Usage with Eurorack:
Analogue Systems' modules are designed solely for use in cases and cabinets made by Analogue Systems. Through the use of adaptors or adaptor cables, however, it is possible to connect them to Eurorack cases.
Should you chose to use an Analogue Systems module in an Eurorack case, please note that the warranties are thus void and the use occurs at your own risk! If the module is plugged in incorrectly and therefore damaged the customer has to bear any costs for repair and shipping!

Because of the different position of the mounting holes there will be a gap of 0.5HP (= 2.5 mm) when mounting an Analogue Systems module next to a Eurorack module. Take this into consideration when planning your system. Gaps can be covered with 1.5HP wide blank panels by Doepfer.

connectors

CV inputs: 1V/oct, vary, shape pulse, shape sine/triangle
Audio outputs: pulse, sine, saw/triangle (also CV In for symmetry of the sine)

dimensions

3U module in Analogue Systems form factor, 12HP wide, 65mm deep
Current draw: 70mA typical; 90mA when powering up

Weight
0.225 kg
Article Number
AORS095e
availability ? immediately available
€ 19% VAT excl. €231.09 € 19% VAT incl. €275.00
Excl. 19% VAT, Excl. shippingLieferzeit 1