Rebel Technology – Logoi

Λόγοι, or written in latin letters, "Logoi" is an Eurorack module specialized in processing clocks. It can divide clocks, count, add and delay them. This adds life to your clock signals, gives shuffle and swing or  totally strange rhythmical stuctures.

The module needs an additional +5V operating voltage

Logoi´s left section is responsible for dividing clocks, commonly called a clock divider. It´s divisor "n" can be set manually or voltage controlled from 1-32.

The right section is busy adding clocks by the addend "m" that can be set manually and /or with voltages. It can either add clocks or delay them, depending on the switch position (see below).

Each section has a dedicated clock input and clock output. Clock from left section is normalized to the right section. There is also a combined output for divisor "n" and addend "m", reading out both sections simultaneously but it´s behaviour depends on the mode set for the right section:

A global reset input resets both sections simultaneously. If you flip the switch to top position you can do a manual reset.

divider sekcion: Clock input, divider output, CV input with attenuator

addition section: Clock input, addition output, CV input with attenuator

global reset input, combined clock output

3U Eurorack module, 10 HP wide, less than 30mm deep.

Current draw unknown yet, the module requires additional +5V to operate.

Suitable 5V adaptors are available from Doepfer (product id: "A-100AD5") and Make Noise (product id: "MN5V").