4ms Rotating Clock Divider DIY kit


DIYers can build a 4ms Rotating Clock Divider by themselves. All electronic components as well as the blank PCB and a faceplate are included. Although the english manual explains the buildup process quite good you should bring some knowledge in electrotechnics and soldering  skills.



Contained are:

  • a bill of parts
  • a faceplate
  • an unpopulated PCB
  • 11x 3,5mm jacks
  • 9x LEDs (2x red, 2x yellow, 2x green, 2x blue, 1x white)
  • a number of headers, jumpers, transistors, resistors, capacitors, ICs and IC sockets.
  • flat ribbon cable 16-pin, 20cm long

Technical info about the RCD can be found on the product page of the ready made module under the product id: "4msRCD".

As with all DIY kits: We are not responsible if your kit does not work or if something gets damaged. We can´t give advice how to solder or how to build the kit. If you are not sure if you can finish the project, then don't start it.

0.1 kg
Article Number

This item is discontinued or sold out and no longer available, please feel free to look for comparable new stuff in the following categories.