All inputs and outputs are DC-coupled i.e. you can use the module to process audio, LFOs, gate signals etc. LEDs show positive and negative signals. All functions except stage 4 can be set manually and voltage controlled.
Stage 1 works as an attenuator, attenuverter or a VCA. It has voltage and manual control, up to 100% attenuation and up to 2x gain. non-inverting and inverting output.
Stage 2 generates an offset voltage (or: bias) and can be used as a fixed voltage generator or attenautor. Fixed voltage in the range of +/-10 Volt, full attenauaton possible
Stage 3 is a bipolar voltage controlled clipper that will cut off the signals peaks. Use it for distorting signals or for attenuation.
Stage 4 is a voltage controlled half-wave rectifier that will remove the negative part of the signal. It has no controls but two outputs for non-inverting and inverting rectification.
Stages 1-3: signal input, CV input, signal output
Stage 4: signal input. Outputs for positive-going, non-inverted, half-wave rectification and negative-going, inverted, half-wave rectification.
3U Eurorack module, 10HP wide, 22mm deep
Average current draw: 85mA
This item is discontinued or sold out and no longer available, please feel free to look for comparable new stuff in the following categories.