Four different signals, CVs or audio signals can be switched to one output - it is not possible vice-versa as the RS-150 module isn't bi-directional.
Switching is generally done with a trigger or clock signal at the Clock input but it can be handled manually with the STOP / RUN / STEP switch that has three different modes:
- STOP: the chosen input will be held. incoming triggers will be ignored
- RUN: the switch reacts to triggers at the clock input and will swithc thru the inputs
- STEP: switching is done manually by flipping the switch to "step"-position
The reset function allows for setting the switch back to step 1. This can be done at any given time by a trigger signal at the reset jack or automatized by the reset switch that will shorten the maximal sequence length between 2, 3 or 4 steps.
Usage with Eurorack:
Analogue Systems' modules are designed solely for use in cases and cabinets made by Analogue Systems. Through the use of adaptors or adaptor cables, however, it is possible to connect them to Eurorack cases.
Should you chose to use an Analogue Systems module in an Eurorack case, please note that the warranties are thus void and the use occurs at your own risk! If the module is plugged in incorrectly and therefore damaged the customer has to bear any costs for repair and shipping!
Because of the different position of the mounting holes there will be a gap of 0.5HP (= 2.5 mm) when mounting an Analogue Systems module next to a Eurorack module. Take this into consideration when planning your system. Gaps can be covered with 1.5HP wide blank panels by Doepfer.
Four inputs, one output
reset input, clock input
3U Analogue Systems module, 6HP wide
16mA power consumption