Analogue Systems RS-240 Bode Freq Shifter

Overview

Faithful reproduction of the legendary and rare analog frequency shifter from the Moog modular system, designed by Harald Bode. The RS-240impresses with features like exponential and linear shifting scales, integrated squelch circuitry, very clear sound and several audio outputs ... yeah, and by that HUGE knob ;)

Views

Details

Amount of frequency shift is controlled by CVs and manually, on the one hand by the big knob and on the other hand by the rotary control that selects between different scales:

  • ZERO: no frequency shift
  • EXP: exponential frequency shift for unusual effects. The input frequency will be multiplied by a certain factor. e.g. when doubling the control voltage the frequency will be shifted one octave upwards (double frequency) and an octave downwards (=half frequency). The maximum frequency shift is around ±2kHz.
  • The positions "5" - "5kHz" select the maximum frequency shift of ±5Hz, ±50Hz, ±500Hz and ±5kHz. Linear frequency shift means that the signal is downshifted upshifted by the same amount in Hertz. E.g at 1V at the CV input the signal is shifted 1kHz up- and downwards. All harmonic relationships will be eliminated that way.

After each change of scale you should re-adjust the point of zero shift with the "zero adjust" control. Remove all CVs, set the big knob to zero and fine tune "zero adjust" until the LED goes off.

If the input frequency is lower than the amount of shift in Hertz then the frequency will be "wrapped around" in best thru-zero-style and a positive frequency with negative phase will be produced.

Output A carries only the downshifted signal, output B carries only the upshifted signal. The three MIX outputs have the mixture of down- and upshifted signals and their relationship can be set with the MIX control.

Without input signal or at very low input levels the frequency shifter still produces side-noise that can be reduced with RS-240´s shiftable squelch circuitry which basically is a noise gate. If input level drops below the threshold (adjustable from 0dB to -60dB) the output signal will be gated.

miscellaneous

Usage with Eurorack:
Analogue Systems' modules are designed solely for use in cases and cabinets made by Analogue Systems. Through the use of adaptors or adaptor cables, however, it is possible to connect them to Eurorack cases.
Should you chose to use an Analogue Systems module in an Eurorack case, please note that the warranties are thus void and the use occurs at your own risk! If the module is plugged in incorrectly and therefore damaged the customer has to bear any costs for repair and shipping!

Because of the different position of the mounting holes there will be a gap of 0.5HP (= 2.5 mm) when mounting an Analogue Systems module next to a Eurorack module. Take this into consideration when planning your system. Gaps can be covered with 1.5HP wide blank panels by Doepfer.

The RS-240 requires a +5V operational voltage. Due to the high current draw on the 5V line we recommend the use of the MakeNoise 5V adaptor or the Volts by Mutable Instruments as thte Doepfer 5V adaptor is too weak.

connectors

One audio input, three CV inputs

5 audio outputs:
- A for down-shifted signal
- B for up-shifted signal
- three mix outputs carrying both signals

dimensions

3U Analogue Systems module, 24HP wide, 122 mm deep (!)
70mA power consumption. The module requires +5V.

Weight
1 kg
Article Number
AORS240
former retail price: €1,350.00

This item is discontinued or sold out and no longer available, please feel free to look for comparable new stuff in the following categories.

 

< back to archive