50 user memories to create personal comb filter, flanging, chorus, pitch shifting and echo programmes. Can recreate bbd and tape echo effects and up to 29 seconds available in mono mode. 2 modes of delay are available Tape Delay and the recently developed Digital Delay. In sample mode the user can voltage control and trigger the source material in ways unavailable until now.
Using the RS295 optional expander samples can be dumped and retrieved using Sys Ex dumps.
NOTE: specifications can change where Analogue Systems deem it appropriate.
Usage with Eurorack:
Analogue Systems' modules are designed solely for use in cases and cabinets made by Analogue Systems. Through the use of adaptors or adaptor cables, however, it is possible to connect them to Eurorack cases.
Should you chose to use an Analogue Systems module in an Eurorack case, please note that the warranties are thus void and the use occurs at your own risk! If the module is plugged in incorrectly and therefore damaged the customer has to bear any costs for repair and shipping!
Because of the different position of the mounting holes there will be a gap of 0.5HP (= 2.5 mm) when mounting an Analogue Systems module next to a Eurorack module. Take this into consideration when planning your system. Gaps can be covered with 1.5HP wide blank panels by Doepfer.
The RS-290 requires a +5V operational voltage. Due to the high current draw on the +5V line we recommend the use of the MakeNoise 5V adaptor or the Volts by Mutable Instruments as the Doepfer 5V adaptor is too weak.
signal input, outupt L, output R (also used as feedback send), feedback return.
CV inputs for repeat speed (or sample start point), feedback gain (or sample end point) and one assignable CV in (or sample pitch)
two trigger inputs
3U Eurorack module, 36HP wide (see above), 115mm deep
Current draw: max. 70mA @ +/-12V and 360mA @ +5V
The module needs a strong +5V voltage adaptor like Mutable's Volts.