The noise generator produces classic analog noise. A potentiometer sets it's output level.
The sample and hold section is very exact and can hold a value almost infinitely. The signal to be sampled is patched to the "ext src in" jack. The trigger that determins the point of sampling is inserted into the "ext clk in" socket. Alternatively you can trigger the S&H manually with the One Shot button if no trigger is inserted to the jack.
The clock generator produces a pulse wave between 0V and 10V. The frequency can be set in a range of 0.15Hz to 30Hz and is visualized with a LED.
Usage with Eurorack:
Analogue Systems' modules are designed solely for use in cases and cabinets made by Analogue Systems. Through the use of adaptors or adaptor cables, however, it is possible to connect them to Eurorack cases.
Should you chose to use an Analogue Systems module in an Eurorack case, please note that the warranties are thus void and the use occurs at your own risk! If the module is plugged in incorrectly and therefore damaged the customer has to bear any costs for repair and shipping!
Because of the different position of the mounting holes there will be a gap of 0.5HP (= 2.5 mm) when mounting an Analogue Systems module next to a Eurorack module. Take this into consideration when planning your system. Gaps can be covered with 1.5HP wide blank panels by Doepfer.
S&H: inputs for sample signal and for trigger signal. S&H output.
Clock: clock output
3U module in Analogue Systems form factor, 12HP wide
power consumption 25mA