The frequency range is selected by a switch between LFO and audio, two potentiometers set coarse and fine tuning. Modulation-wise there are three CV inputs: FM 1 is equipped with a polarizer, FM 2 with an attenuator, FM 3 is not attenuated. FM 2 and 3 track one Volt per octave.
The left four quadrature outputs with 0°, 90°, 180° and 270° phase provide you with either a sine or a triangle which is switch-selectable. The right four quadrature outputs are responsible for pulse wave and sawtooths. The pulse width is set manually and per CV, the form of the sawtooth is selectable between sawtooth, ramp and a mix of both, even via CV.
Further possibilites of manual and voltage control are the bipolar DC offset and the output level. Finally there's even a sync input which tops off PH-8's VCO capabilities.
All Cwejman modules are screened against interferences, protected against reverse polarity and contain calibration options on the backside. (See photograph.)
Attention: Unlike other manufacturers, the red stripe of Cwejman's flat ribbon cable indicates the positive +12 V rail, not the negative one!
We currently do not accept pre-orders for Cwejman modules. For some products, there are waiting lists with pre-orders from the years 2013 to 2017, which are being processed as a matter of priority.
If you’d like to be informed as soon as this module is back in stock, please activate the availability notification via e-mail.
Please note: The number of Cwejman modules is always limited and much lower than the number of interested parties. Therefore, we recommend to order IMMEDIATELY and ONLINE if a Cwejman product becomes available. Enquiries via e-mail or telephone are usually not fast enough.
If the demand is higher than the supply, unfulfillable pre-orders will be deleted. In this case you’ll receive an e-mail. (Pre-orders on the waiting lists mentioned above are excluded from this policy.)
triangle/sine outputs: 0°, 90°, 180°, 270°
saw/pulse outputs: 0°, 90°, 180°, 270°
CV inputs: offset, level, saw switch, FM 1-3, Sync, PWM
3U Eurorack module, 20 HP wide, 23 mm in depth
Power consumption: 50 mA at +12 V