Intellijel Designs - Dixie II+


The slightly larger brother of the Dixie II is built around the same triangle core yet it has some additional features which make it more versatile. Octave switch, a fine tune control, control of PWM intensity, enhanced FM section and one special inverting sync input.
So, if you're looking for a full-fledged primary oscillator - here it is!



The oscillator frequency is set by a eight-position octave switch, a fine tune control and by a switch selecting between LFO and audio rates.
For modulating the frequency by CVs there are a 1V/octave input, the exponential FM2 input as well as another FM input with scalable modulation intensity and which can be used wither as a linear or exponential FM input.

The initial pulse width is adjusted with the PWM control between 10% and 90%. Via the attenuated PWM input it can be modulated by a ±5V control voltage from 0% to 100%.

Oscillator synchronisation can be done in two different ways: SYNC resets the VCO to zero when the input wave crosses zero; via FLIP the oscillator changes its direction of travel.

Besides the four standard waveforms sine, triangle, pulse and sawtooth there's also a zigzag wave and a sub-oscillator which outputs a pulse with 50% duty cycle, swinging one octave below.


The narrower Dixie II is not discontinued but will be built in parallel with the II+. This way you might use the II+ as primary oscillator and the Dixie II as a secondary oscillator with the same sound.


inputs: FM1, FM2, 1V/octave, PWM, sync, flip
waveform outputs: sine, triangle, zigzag, saw, pulse, sub-oscillator


3U Eurorack module, 8HP wide, 40mm deep
Power consumption: 70 mA at +12 V and 60 mA at -12 V

0.187 kg
Article Number
availability ? shortly avaliable
€ 19% VAT excl. €205.88 € 19% VAT incl. €245.00
Excl. 19% VAT, Excl. shippingLieferzeit 1 Tag