The connectors and control elements of the Mod Tools are divided into four sections. At the top of the front panel, there is a function generator, which can be used as an envelope or LFO. Rise and fall are adjustable by potentiometers. Additionally, there is a CV connector with a bipolar attenuator, which influences both parameters. A sustain phase can be activated via a switch. Thanks to the function generator’s signal input, it is possible to employ the circuit as an envelope follower as well.
The analog logic stage can be used to mix two signals. Results are emitted via the mix socket. Furthermore, there is a circuit which determines the currently highest positive voltage from either of the signals. It can be tapped off the Or connector.
The third section of the Mod Tools module offers a Sample & Hold circuit with inputs for trigger signals and material to be processed. An output emits the results. Additionally, there is a noise generator.
Last but not least, Mod Tools comes equipped with an LFO. It features a frequency knob as well as sine and square outputs.
Signal input and output
CV input for rise and fall parameter
Two signal inputs
Mix and Or outputs
S&H / noise:
Trigger and sample inputs
S&H and noise outputs
Modulation: Sine and square outputs
3U Eurorack module, 8 HP wide, 37 mm deep
Current draw: 53 mA at +12 V and 46 mA at -12 V
This item is discontinued or sold out and no longer available, please feel free to look for comparable new stuff in the following categories.