Details
Red illuminated faders are used for setting the step voltage from 0 to 5V. At clock speeds in audio range you can use the faders t draw waveforms, similar to a graphic oscillator. The length of the sequence can be adjusted fro one to eight steps with a rotary switch. If the sequencer loos or if it plays only once can be set with the "at end"-switch. changes won't become active until the next cycle, which is very useful in a live context to allow more dynamic planning.
Resetting the sequencer to step 1 is possible by a gate signal at the "stage 1 input". The "stage 1 output" generates a 5V gate signal when reaching the first step.
With the optionally available module Time Buffer you can synchronize up to eight Graphic Sequencers to a DIN Sync signal. The "division" switch at the Graphic Sequencer selects if the module runs in quarter, eighth or sixteenth-note rate. Chenges of this parameter will not take effect until the unit returns to stage one.
The module requires ONLY a 5V operational voltage. make sure the power supply of your system generates this voltage.
Inputs: "shift input" (=clock input), "stage 1 input" (= reset input) Outputs: "stage 1 output" (=step 1 gate out), "voltage output" (=sequencer CV output)
3U Eurorack module, 14HP wide
It needs only a +5V voltage to operate!
This item is discontinued or sold out and no longer available, please feel free to look for comparable new stuff in the following categories.